Slide the CaP on to the coaxial cable. Insert the coaxial cable into the side slot of the stripping tool (SPC) about 1cm (3/8''); gently squeeze the blades while pulling the cable out to slit both sides of the jacket. Expose the dielectric by pushing backwards the jacket and the braid. Insert the cable in the round hole until the dielectric just peaks on the other side. Rotate the tool + -90° while squeezing the blades to cut and remove the dielectric. The cable is ready.
ProCaP - Professional pliers
Coaxial connection with ProCaP
INSTALLATION: Insert the centre conductor into the F female connector and fold the braid and the jacket over the thread by sliding the CaP over it. Lay the coaxial cable through the flat side of the professional pliers (ProCaP). Slip the connector groove in the fingers on the far side. Gently squeeze the pliers to secure the connector. Unlike compression connectors, CaP does not require force.
REMOVAL: With the ProCaP fully open, insert the connector groove in the middle fingers and squeeze the handles to open the connection.
Pi-CaP - Economical pliers
Coaxial connection with Pi-CaP
INSTALLATION: Insert the centre conductor into the F female connector and fold the braid and jacket over the thread by sliding the CaP over it. Insert the connector between the handles tip of the economic pliers (PiCaP). To terminate the connection squeeze the handles, placing your hand near the connector to obtain greater leverage.
REMOVAL: Insert the connector groove in the fingers (closed) at the top of the PiCaP and squeeze the handles to open the connection.
Pu-Pu CaP - Inserter
Coaxial connection with Pu-Pu CaP
INSTALLATION: Insert the CaP in the specific groove positioned at the top of the Pu-PuCaP and insert the central conductor into the F female connector. Slide the CaP over the F female, thus folding the braid and the jacket over the thread. Terminate the connection by swinging and at the same time pushing forward the Pu-PuCaP up to the complete insertion of the CaP onto the F female connector.
REMOVAL: Hook the Pu-PuCaP on the CaP by means of the specific groove of the tool. Swing and at the same time pull down the Pu-PuCaP up to the complete disconnection of the CaP and the cable from the device.