CaP as coaxial connector

CaP, when used with our specific F female adapters, becomes a coaxial connector in any available standard (IEC, RCA, BNC, F, …) male or female, straight or right angled, 50 or 75 Ohm.

For high professional use are available our BNC HQ male and GC HQ adapters (Return Loss > 30 dB @ 3 Ghz).

Features of our adapters

All our adapters have been specifically designed to reach optimal performances when used with the CaP, thanks to their unique features:

central groove: to allow for a solid engagement with the pliers during installation and removal;

internal structure: specific dielectric and elastic yet strong clip, to have a better contact with a large range of conductors;

external body: single and compact element, to have smaller dimentions and lower signal losses.

Terminate connection with ProCaP

1

INSTALLATION

After the cable preparation (see instructions here) , insert the centre conductor into the F female connector and fold the braid and the jacket over the thread by sliding the CaP over it. Lay the coaxial cable through the flat side of the professional pliers (ProCaP). Slip the connector groove in the fingers on the far side. Gently squeeze the pliers to secure the connector. Unlike compression connectors, CaP does not require force.

2

REMOVAL

With the ProCaP fully open, insert the connector groove in the middle fingers and squeeze the handles to open the connection.

Terminate connection with PiCaP

1

INSTALLATION

After the cable preparation (see instructions here) , insert the centre conductor into the F female connector and fold the braid and jacket over the thread by sliding the CaP over it. Insert the connector between the handle tips of the economic pliers (PiCaP). To terminate the connection squeeze the handles, placing your hand near the connector to obtain greater leverage.

2

REMOVAL

Insert the connector groove in the fingers (closed) at the top of the PiCaP and squeeze the handles to open the connection.